Emtek Key In Knob with #8 & #1 Rosette (Adjustable L Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Pro domov Emtek Key In Knob with #8 & #1 Rosette (Adjustable L. Emtek Key In Knob with #8 & #1 Rosette (Adjustable Latch) User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 1
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
Outside Trim
Inside Trim
10-22-2012 IN4-KEYNKNB8
Installation Guide - For Key in Knob with #8 Style Rosette
Lock Assembly
Re-pinning Cylinder (Optional)
Step 2. Rotate key counterclockwise 90º while
pressing wire into hole.
Step 3. Slide knob off stem.
For more information on rekeying
cylinder, please scan the QR code for
how-to video.
Step 1. Small hole should face down.
Door Prep 2. Install Adjustable Latch1. Install Strike Plate
3. Remove Inside Rosette
Step 2. Unthread locking ring
counterclockwise to remove
rosette from housing before
installing on door.
Step 1. Remove inside knob by
loosing set screw w/ hex wrench
(provided).
4. Installing Inside Trim
Step 1. Secure inside rosette to door by threading
locking ring clockwise on to stem.
Step 2. Tighten knob set screw after placing knob on
stem.
Spanner
wrench,
(provided).
Flat spindle
MUST
be in horizontal
position for
installation
Plunger spindle
MUST
be in horizontal
position for
installation.
Fasten Strike Plate using
Two #8 x 3/4” Wood Screws
(provided).
Fasten Adjustable Latch using two
#8 x 3/4” Wood Screws (provided).
!
To remove Pin:
Push Plastic Latch Pin
through latch with
screwdriver.
Scan this
QR code for
installation
video
Plastic Latch Pin
Plastic
Latch Pin
The Adjustable Latch is factory shipped with a 2¾”
backset position. Remove pin and slide spindle hub
forward for a 23/8” backset, then reinsert the pin in
the hole at the back of the latch as shown.
2 ⁄”
or 2 ¾”
Backset
2 ⁄”
Dia.
Bore
⁄” Deep
2 ¼”
1 “
1” Diameter
Edge Bore
Zobrazit stránku 0
1

Shrnutí obsahu

Strany 1 - Push Plastic Latch Pin

Outside TrimInside Trim10-22-2012 IN4-KEYNKNB8Installation Guide - For Key in Knob with #8 Style RosetteLock AssemblyRe-pinning Cylinder (Optional) S

Komentáře k této Příručce

Žádné komentáře